![]() ![]() This didn't give a KP, but it still didn't work with either card (9201-8i and 9205-8e). Then I tried copying them to /System/Library/Extensions. This resulted in a KP on boot when an LSI was installed, but not if it wasn't. First I copied the files - AstekFusion2Adapter.kext and AstekFusion2Family.kext - into EFI/CLOVER/kexts/Other . The drivers uploaded by kurbads, labelled as being for 2308 cards. I don't know if this a problem, given I do have kext-dev-mode=1?Ģ. However I do note that in System Report that as well as Loadable=No, it says "Signature Validation Errors: Not Signed". I have added kext-dev-mode=1 to my Clover boot settings, as per instructions for 10.10 and later. This boots OK, but I see no card or drives, and System Report shows "SASMegaRAid" as Loaded=No and Loadable=No. Installed MegaSAS package mentioned in the OP. I have tried two different PCIe 2.0 x8 slots, just to rule that out as a potential cause.ġ. I have tested both with a drive connected to the card, and with no cables connected. The LSI cards are known to be working fine. Both are on the latest available FW (version 20), and both are in IT mode (non-RAID). I am testing with two LSI cards: an LSI 9205-8e (2308 controller) and an LSI 9201-8i (2008 controller). I'm on macOS 10.13.3 using the latest Clover (4411). I've tried both the OP MegaSAS package, and the Antek*.kext files uploaded as "2308 drivers" by kurbads. Or I'm doing something wrong - which is very likely. I'm trying to get an LSI 92XX (non-MegaRAID) card working in my Hackintosh, and unfortunately I'm not quite so lucky. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |